Many High Powered amplifiers do not necessarily have a good sound at normal listening levels however, high power is necessary to drive some loudspeakers to realistic sound levels. LUXMAN has overcome many problems associated with the high frequency performance by carefully optimising every stage from the input to its full complementary output stage. This has necessitated the design of special high voltage high speed complementary transistors for the outputs. Protection of both loudspeakers and amplifier under adverse conditions is a necessity. That is why the M-6000 have incorporated Speaker Protection Circuitry that senses abnormal D.C. potential in the output, plus Amplifier Protection Circuitries by means of over-temperature power limiting and over-current limiting sensors. Special circuitry is used in the unlikely event of a single power output transistor failing to allow continued operation. With the M-6000 monitoring of the output is displayed in two ways - Large V.U. Meters read out the Average power and LED read out the equivalent Peak instanteous power, which enables you to see the Dynamics of the Music you are listening to. A bronze anodized brushed aluminium is used for the front panel and incorporated in it is the 1dB level set controls, a large easy-to-use Power switch plate and meter function push buttons. The rear of the unit contains an exclusive "Honey-Comb" heat sink. All this gives a solid "feel' to the unit. The LUXMAN M-6000 was the first from the 50th Anniversary lineup of "Ultimate High Fidelity Stereo" components introduced in 1975 and designed by Tim de Paravicini. Technical specifications: Power output 2x300 W (8 ohm, 20Hz-20Khz, 0.05% THD) | THD: 0.05% | Frequency response: 5Hz-50Khz | Dimensions: 570x425x220 mm | Weight: 52 kg. | Matching pre-amplifier: Luxman C-1000.
